Started as a stock 1993 Ranger supercab Xlt 4X4.  Now it has a 5.0HO Full Roller/MSD Ignition/Edelbrock Carb & RPM Air gap/Manual shift AOD/Np208/ Full width HP44 and 9" with 5.13 gears and a locker up front mini spool out back.  I normally run 38.5/15-15 boggers but also have 35" MTs and 20" wide paddles for the rear.  I have also added ladder bars, on-board air, LOUD air horn, and a CB.

I started this back in november 2006 as just an axle swap.  Then I wanted more power and then bigger tires, which requires more lift and the list goes on.

hey i did find a nice little mud/water hole for you and your 38.5 boggers if you wanna try it

I know  working on it.

New Hi-Lift Extreme Jack and Mount.  Mount also doubles as a CB antenna mount to keep the 8' Whip away from body work.

Waychoff05 at 12:38AM on Apr 09, 2009

hey i did find a nice little mud/water hole for you and your 38.5 boggers if you wanna try it

where at?

nice build up, looks sweet in that side view -

so whats your next move ?

in allegan at a buddys house i took my jeep in there yesterday and only made her a good 3 feet till the front end was almost under water and my feet got wet so i backed out

good looking truck, now you need to get that other monster of a ford of yours goin:D

jeepnxj96 at 09:33AM on Apr 09, 2009

good looking truck, now you need to get that other monster of a ford of yours goin:D

Tell me about it.  I wish I had them both going right now, but I wanted my ranger done sooo bad since it has the HP, gears and lockers, new tires, and it has never really been offroad since the rebirth.  As soon as I get the leak fixed on the ranger I will be back onto the F250.

i miss my barn....  I haven't even been in rickys in a long time.... 

so did you get the transmission fixed? I have seen this truck in person and it is nice, I'm not much of a ford guy but I like this ranger.

talk to ricky i gave him some really nice zip ties to tie that big wip up

I am going to make a second mount to lay the antenna flat when I am not using the CB.

Also, new (to me) tube bumpers should be installed by saturday

TBSDontStop at 11:29PM on Apr 09, 2009

so did you get the transmission fixed? I have seen this truck in person and it is nice, I'm not much of a ford guy but I like this ranger.

Yeah, I ended up getting another one off Craigslist and put that up in the truck.  The full manual valve body is f-ing bada$$.  I can bark 35's at the 1-2 and 2-3 shifts even with the rear spooled.

New Front and rear bumpers are finally installed.  Thanks to Waychoff05 for helping out.  Driveline is back together, coolant leak is fixed, hopefully it will be leak free and I will have it at the meeting saturday.

thoes bumpers look nice on there lookin good.

hope ta see it at the meeting.

looks good Brandon

are you going to put the mesh behind that front bumper still?

Waychoff05 at 08:33AM on Apr 23, 2009

are you going to put the mesh behind that front bumper still?

Not really sure what to do yet.  Ricky stopped over today and we did some brainstorming, I thing I might put some rubber in the gap for now just to cover it up until I figure out a better way to fill it.